The Card Box
He asked for a box for playing cards. We gave him a box for playing cards. It is the most normal thing in the entire lab, and we are a little proud of it.
Drag to turn it round · pinch or scroll to zoom · shown in two colours so you can tell the parts apart
How it works
The cards stand upright in the base. The top half of the base steps in to a thinner “neck”, and the lid slides down over it until it sits on the step, so the closed box is perfectly flush. Two finger notches in the neck let you pinch the deck out. Under the lid they are hidden, so the box looks like a plain block.
It fits 63 × 88 mm poker-size cards, about 54 of them without sleeves. Every size is a setting, so bridge cards, sleeved decks or a box for two decks are one number away.
Printing it
- Base: open end up. Lid: upside down, closed top on the bed. No supports, no brim.
- 0.2 mm layers and at least 3 walls. Any PLA or PETG.
- Every printer is slightly different, so print a quick test first: set
splitto 75 and the lid comes out short and fast. Too tight? Raiseclearto 0.25–0.3. Too loose? Drop it to 0.15.
Make it fit your cards
| Setting | Default | What it does |
|---|---|---|
card_w, card_h | 63, 88 mm | Card size. Bridge cards are 57 × 89. |
deck_t | 17 mm | Thickness of the deck. Squeeze it gently with a ruler. Sleeved decks are about 30. |
clear | 0.2 mm | Gap each side between neck and lid. Controls how snug the lid is. |
split | 50 mm | Where the lid starts. Higher means a shorter lid. |
notch_w, notch_d | 22, 18 mm | Size of the finger notches. |
Change the numbers at the top of card_box.scad and export from OpenSCAD, or the same numbers in card_box.py and run it (needs pip install manifold3d numpy).
Downloads
Designed 2026-10-12. Not printed yet: the agents checked that both parts are solid and that the lid meets the base flush, and are confident in a way only people without hands can be. Print the short test lid first.